| Class | Description |
|---|---|
| AdvancedLoosePartFeeder | |
| BlindsFeeder |
Implementation of Feeder that indexes through an array of cut tape strips held
by a 3D printed base.
|
| BlindsFeeder.NozzleAndTipForPushing | |
| ReferenceAutoFeeder | |
| ReferenceDragFeeder |
Vision System Description
The Vision Operation is defined as moving the Camera to the defined Pick Location, performing a
template match against the Template Image bound by the Area of Interest and then storing the
offsets from the Pick Location to the matched image as Vision Offsets.
|
| ReferenceDragFeeder.Vision | |
| ReferenceHeapFeeder |
Implementation of the HeapFeeder.
|
| ReferenceHeapFeeder.DropBox | |
| ReferenceHeapFeeder.DropBoxProperty |
This class is just a delegate wrapper around a list.
|
| ReferenceHeapFeeder.HeapFeederHelper |
This class contains some methods used in the dropBox and the Heap
|
| ReferenceLeverFeeder |
Vision System Description
The Vision Operation is defined as moving the Camera to the defined Pick Location, performing a
template match against the Template Image bound by the Area of Interest and then storing the
offsets from the Pick Location to the matched image as Vision Offsets.
|
| ReferenceLeverFeeder.Vision | |
| ReferenceLoosePartFeeder | |
| ReferencePushPullFeeder | |
| ReferenceRotatedTrayFeeder |
Implementation of Feeder that indexes based on an offset.
|
| ReferenceSlotAutoFeeder | |
| ReferenceSlotAutoFeeder.Bank | |
| ReferenceSlotAutoFeeder.BanksProperty |
This class is just a delegate wrapper around a list.
|
| ReferenceSlotAutoFeeder.Feeder | |
| ReferenceStripFeeder |
SMD tape standard info from http://www.liteplacer.com/setup-tape-positions-2/
holes 1.5mm
hole pitch 4mm
first part center to reference hole linear is 2mm
tape width is multiple of 4mm
part pitch is multiple of 4mm except for 0402 and smaller, where it is 2mm
hole to part lateral is tape width / 2 - 0.5mm
|
| ReferenceTrayFeeder |
Implementation of Feeder that indexes based on an offset.
|
| ReferenceTubeFeeder |
Implementation of Feeder that always picks from the same location.
|
| SchultzFeeder | |
| SlotSchultzFeeder | |
| SlotSchultzFeeder.Bank | |
| SlotSchultzFeeder.BanksProperty |
This class is just a delegate wrapper around a list.
|
| SlotSchultzFeeder.Feeder |